Kia Optima: Removal - Front Impact Sensor (FIS). Repair procedures - SRSCM - Restraint - Kia Optima TF 2011-2023 Service ManualKia Optima: Removal

Removal of the airbag must be performed according to the precautions/ procedures described previously.
Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).
Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2. Remove the air duct (A).

3. Loosen the radiator upper hose bolt (A).

4. Remove the radiator mounting bracket (B).

5. Disconnect the front impact sensor connector (A).

6. Loosen the front impact sensor mounting nut (B) and remove the front impact sensor.

Front Impact Sensor (FIS). Repair procedures
...

Installation
• Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact s ...

See also:

Disassembly
1. Remove the dust packing & cap (A) from the pinion housing. 2. Loosen the lock nut and then remove the tie rod end (B) and lock nut (A) from the tie rod ...

Rear Cross Member. Repair procedures
Replacement 1. Remove the rear wheel & tire. Tightening torque:88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

Emergency trunk safety release
Your vehicle is equipped with an emergency trunk release lever located inside the trunk. If someone is inadvertently locked in the trunk, moving the handle in the direction of the arrow will rel ...

Copyright © www.kiopman.com 2023