Kia Optima: Installation
| • |
Do not turn the ignition
switch ON and do not contact the battery cable while replacing the
front impact sensor. |
|
| 1. |
Install the new front impact
sensor. |
| 2. |
Tighten the front impact sensor
mounting nut.
Tightening torque:
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)
|
|
| 3. |
Connect the front impact sensor
connector. |
| 4. |
Install the radiator mounting
bracket.
Tightening torque:
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
|
|
| 5. |
Tighten the radiator upper hose
bolt. |
| 6. |
Reconnect the battery negative
cable. |
| 7. |
After installing the Front Impact
Sensor, confirm proper system operation:
| A. |
Turn the ignition switch
ON; the SRS indicator light should be turned on for about six seconds
and then go off. |
|
•
Removal of the airbag
must be performed according to the precautions/ procedures described
previously.
...
Description
Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each
center of the front door module (LH and RH) and two SIS which are installed at each
center pillar nea ...
See also:
Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove wheel nuts, front wheel
and tire from front hub.
...
Components (2)
1. Backing plate
2. Operating lever
3. Upper spring
4. Lower spring
5. Adjuster
6. Shoe hold down spring
7. Shoe hold down pin
8. Shoe
...
Tightening Torque Table Of Standard Parts
Bolt nominal diameter (mm)
Pitch (mm)
Torque Nm (kg.cm, lb.ft)
Head Mark 4
Head Mark 7
...
Removal
Side Impact Sensor (SIS). Description and Operation