Kia Optima: Side Impact Sensor (SIS). Description and Operation
Description
Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar nearby (LH and RH).Side Pressure Sensor is also called P-SIS because it detects pressure due to collision at its mounting location.
Side Impact Sensor is also called A-SIS because it detects acceleration.SRSCM decides deployment of the airbag and the time of deployment through the collision signal of the SIS when the collision occurred.
Installation
•
Do not turn the ignition
switch ON and do not contact the battery cable while replacing the
front impact ...
Side Impact Sensor (SIS). Components and Components Location
Components
...
See also:
Power Steering
Checking the Power Steering Fluid Level
With the vehicle on level ground, check the fluid level in the power steering
reservoir periodically. The fluid level should be between MAX and MIN indicat ...
Diagnosis procedure by using diagnostic device
As manual for diagnosis methods by using diagnosis device, the main contents are
as follows:
1.
Connect self-diagnosis connector(16pins)
located in the lower of driver side crash pad to ...
Installing a Child Restraint System in the Rear Center Seat
To install a child restraint in the rear center seat, do the following:
1. Place the child-restraint in the desired position. Route the lap/ shoulder
belt through the restraint according to the s ...
Categories
Kia Optima Manuals
- Kia Optima DL3 2019-2026 Owners Manual
- Kia Optima DL3 2019-2026 Service and Repair Manual
- Kia Optima TF 2011-{2019} Owners Manual
- Kia Optima TF 2011-2026 Service Manual
- Kia Optima MS/Magentis 2000-2005 Owners Manual
