Kia Optima: Removal - Filler-Neck Assembly. Repair procedures - Fuel Delivery System - Engine Control/Fuel System - Kia Optima TF 2011-2023 Service ManualKia Optima: Removal

1. Lift the vehicle.
2. Disconnect the fuel filler hose (A).
3. Disconnect the ventilation hose (B) from the fuel tank air filter.

4. Open the fuel filler door and then remove the filler-neck installation screw (A).

5. Remove the rear-LH wheel, tire, and the inner wheel house.
6. Remove the filler-neck assembly from the vehicle after removing the bracket installation bolt (A).


Filler-Neck Assembly. Repair procedures
...

Installation
1. Installation is reverse of removal. Filler-neck assembly bracket installation bolt : 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft) Filler-neck as ...

See also:

Measurement Point
Measurements should be taken at the center of the hole. ...

Inspection
1. Turn ignition switch OFF. 2. Disconnect the oil temperature sensor connector. 3. Measure resistance between sensor signal terminal and sensor g ...

Inspection
1. Measure the pressure of high pressure line by measuring voltage output between NO.1 and NO.2 terminals. 2. Inspect the voltage value whether it is sufficie ...

Copyright © www.kiopman.com 2023