Inspection
1. | Disconnect the negative (-) battery terminal. |
2. | Remove the front door trim panel. (Refer to the BD group - "Front door") |
3. | Disconnect the connector and
remove the door mirror switch (A) after removing the screws.
|
4. | Check for continuity between
the terminals in each switch position according to the table. [Power Mirror Switch]
|
Window opening and closing
Type A
The driver’s door has a master power window switch that controls all the windows
in the vehicle.
To open or close a window, press down or pull up the front portion of the corresponding
...
Removal
1.
Disconnect the battery negative
cable, and wait for at least three minutes before beginning work.
2.
To remove the seat belt anchor
pretensioner (C), keep on push ...
To resume cruising speed at more than approximately 40 km/h (25 mph)
If any method other than the cruise ON/OFF switch was used to cancel cruising
speed and the system is still activated, the most recent set speed will automatically
resume when the RES+ switch is ...