Inspection
1. | Remove the front door quadrant
delta cover. (Refer to the BD group - "Front door") |
2. | Disconnect the power door mirror
connector from the harness.
|
3. | Apply battery voltage to each
terminal as shown in the table and verify that the mirror operates properly.
|
Jump Starting
Jump starting can be dangerous if done incorrectly. Therefore, to avoid harm
to yourself or damage to your vehicle or battery, follow the jump starting procedures
on this page. If in doubt, we str ...
Preparation Of Tools And Measuring Equipment
Be sure that all necessary tools and measuring equipment are available starting
work. ...
Jump Starting Procedure
1. Make sure the booster battery is 12-volt and that its negative terminal is
grounded.
2. If the booster battery is in another vehicle, do not allow the vehicles to
touch.
3. Turn off all unnec ...