Kia Optima: Installation
| • |
Install the component with the specified
torques. |
| • |
Note that internal damage may occur when
the component is dropped. If the component has been dropped,
inspect before installing. |
|
| • |
Apply the engine coolant to the O-ring. |
|
| • |
Insert the sensor in the installation hole
and be careful not to damage.
|
|
| 1. |
Installation is reverse of removal.
|
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Disconnect the engine coolant temperature sensor
connector (A).
...
Description
Crankshaft Position Sensor (CKPS) detects the crankshaft
position and is one of the most important sensors of the engine control system.
If there is no CKPS signal input, the engine ...
See also:
Removal
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Release the residual pressure in fuel line (Refer
to “Release Residual P ...
Automatic Transaxle
...
Anchor Pretensioner (APT). Description and Operation
Description
Front seat belt anchor pretensioner operates as well as belt pretensioner at the
same time If it gets into its deploy condition after a collision. It is located
at near anchor on fron ...
Removal
Crankshaft Position Sensor (CKPS). Description and Operation