Inspection
1. | Disconnect the negative (-) battery terminal. |
2. | Remove the overhead console lamp
assembly. (Refer to the BD group - "Roof trim") |
3. | Check for continuity between
the terminals.
|
4. | If the continuity is not as specified,
replace the panoramaroof switch (A).
|
Side Impact Sensor (SIS) Repair procedures
Removal
Pressure Side Impact Sensor
•
Removal of the airbag must be performed according to the precautions/procedures described previously.
•
Be ...
Removal and Installation
1.
Disconnect the terminals from the battery.
Tightening torque
:(+) terminal (A) : 7.8 ~ 9.8N.m (0.8 ~ 1.0kgf.m,
5.8 ~ 7.2lb-ft)
(-) terminal (B) : 4.0 ...
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of
TPS 1 and 2 at C.T. and ...