Kia Optima: Installation - Repair procedures - Ignition Switch Assembly - Body Electrical System - Kia Optima TF 2011-2023 Service ManualKia Optima: Installation

1. Install the key lock cylinder.
2. Install the key warning switch and key Illumination.
3. Install the key warning/immobilizer connector.
4. Connect the ignition switch connector after Install the ignition switch.
5. Install the wiper switch.
6. Install the steering column shrouds.
7. Install the driver crash pad lower panel.

Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the driver crash pad lower panel.(Refer to the BD group - "Crash pad") 3. Rem ...

Inspection
1. Disconnect the ignition switch connector (A) and key warning switch connector (B) from the steering column. 2. Check for continuity between the ter ...

See also:

Customer Complaint Analysis Check Sheet
There are several areas where a problem can occur: wiring harness, the radio, the CD player, and speaker. Troubleshooting enables you to confine the problem to a particular area. ...

Yaw-rate and Lateral G Sensor. Description and Operation
Description When the vehicle is turning with respect to a vertical axis the yaw rate sensor detects the yaw rate electronically by the vibration change of plate fork inside the yaw rate sensor.If ...

Troubleshooting
Troubleshooting Symptom Possible cause Remedy Hard steering Improper front wheel alignment Excessive turning resistance of lower arm ba ...

Copyright © www.kiopman.com 2023