A blade type fuse test taps provided to allow checking the fuse itself without removing if from the fuse box. The fuse is good if the test lamp lights up when one lead is connected to the test taps (one at a time) and the other lead is grounded. (Turn the ignition switch so that the fuse circuit becomes operative)
Installation
1.
Install the heater control unit.
2.
Install the center fascia panel.
3.
Install the crash pad garnish.
...
Inspection
1.
Check the bushing for wear and
deterioration.
2.
Check the rear lower arm for
deformation.
3.
Check the coil spring and spring
pad for deterior ...
Inspection
Rain Sensing Wiper
1.
In IGN2 ON state, if auto switch
input (LIN communication) is ON then both wiper low relay and wiper high
relay outputs are controlled by the rain sensor input s ...