Kia Optima: Installation
| 1. |
Installation is the reverse of
removal. |
| 2. |
Use a SST (09581-11000) when
installing the brake caliper assembly.
|
| 3. |
After installation, bleed the
brake system. (Refer to Brake system bleeding) |
| • |
Do not hit piston end
by hammer or prying directly against piston face with screwdriver
to push in piston. |
| • |
Use wood or a used pad
to protect piston end. Pushing on the wood or used pad is recommended. |
| • |
When spreading a piston,
all area of piston end face should be protected from using the SST. |
|
Rear Brake Disc Thickness Check
1.
Check the brake pads for wear
and fade.
2.
Check the brake disc for damage
and cracks.
3.
Remove all rust and contam ...
See also:
Steering Gear box. Components and Components Location
Components
1. Tie rod end
2. Lock nut
3. Bellows
4. Bellows band
5. Tie rod
6. Rack bar
7. Dust packing
8. Dust cap
9. Oil seal
10. Pinion plug
...
Installation
1.
The key of crankshaft should
be aligned with the mating face of main bearing cap. As a result of this,
the piston of No.1 cylinder is placed at the top dead center on compression ...
Removal
1.
Turn ignition switch OFF and
disconnect the negative (-) battery cable.
2.
Remove the crash pad lower panel
and reinforcing panel. (Refer to the Body group- crash ...
Inspection