Kia Optima: Installation
1. |
Installation is the reverse of
removal. |
2. |
Use a SST (09581-11000) when
installing the brake caliper assembly.
![](images/books/1428/syfbr0069n.gif)
|
3. |
After installation, bleed the
brake system. (Refer to Brake system bleeding) |
• |
Do not hit piston end
by hammer or prying directly against piston face with screwdriver
to push in piston. |
• |
Use wood or a used pad
to protect piston end. Pushing an the wood or used pad is recommended. |
• |
When spreading a piston,
all area of piston end face should be protected from using the SST. |
|
Front brake disc thickness check
1.
Check the brake pads for wear
and fade.
2.
Check the brake disc for damage
and cracks.
3.
Remove all rust and conta ...
See also:
Repair procedures
Inspection
[System Inspection]
1.
Disconnect the vapor hose from the throttle body
and connect a vacuum pump to the nipple on the throttle body.
2.
Chec ...
ESC Control Module. Components and Components Location
Components
1. Front - left tube
2. Rear - right tube
3. Rear - left tube
4. Front - right tube
5. MC2
6. MC1
7. ESC control module(HECU)
8. Damper
9. Br ...
Removing the Spare Tire
Turn the tire hold-down wing bolt counterclockwise. Store the tire in the reverse
order of removal.
To prevent the jack, jack handle, and tool bag from “rattling” while the vehicle
is in motion ...