Kia Optima: Installation
| 1. |
Installation is the reverse of
removal. |
| • |
When installing, apply
the ATF oil or white vaseline to the O-ring (A) not to be damaged.
|
| • |
Continue to apply liquid
gasket at application points at the valve body cover with Ø2.5mm
(0.0984in.) thickness.
Liquid gasket Part
name :
Threebond 1281B or LOCTITE FMD-546
|
|
| • |
Adding automatic transaxle
fluid. (Refer to "Hydraulic system (Fluid)" in this group) |
|
Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional
hydraulic pressure adjustment; however, the hydraulic pre ...
Description
Inhibitor Switch monitors the lever's position(PRND) and is used to control gear
setting signals.
...
See also:
Underbody Maintenance
Corrosive materials used for ice and snow removal and dust control may collect
on the underbody. If these materials are not removed, accelerated rusting can occur
on underbody parts such as the fu ...
Heater & A/C Control Unit(Manual). Repair procedures
Replacement
1.
Disconnect the negative (-) battery
terminal.
2.
Using the screwdriver, remove
the side cover (A).
3.
Loosen the mounting scre ...
Inspection
1.
Insert a thin stick (A) into the PCV valve (B) from
the threaded side to check that there is the plunger movement.
...
Removal
Inhibitor Switch. Description and Operation