Kia Optima: Removal
|
Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional
hydraulic pressure adjustment; however, the hydraulic pressure will need
to be adjusted after replacing the VFS solenoid valve. If replacing the
VFS solenoid valve; also replace the valve body assembly. (Refer to "Valve
Body" in this group) |
| 1. |
Remove the battery and the battery
tray. (Refer to "Charging system" in EE group.) |
| 2. |
Remove the under cover (A).
Tightening torque:7.8 ~
11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
|
|
| 3. |
Replace new gasket and the plug
after draining the automatic transaxle fluid by removing the drain plug.
(Refer to "Hydraulic system (Fluid)" in this group) |
| 4. |
Remove the valve body cover (B)
and eyebolt (A).
Tightening torque:(A) 34.3
~ 44.1 N.m (3.5 ~ 4.5 kgf.m, 25.3 ~ 32.6 lb-ft)
(B) 13.8 ~ 14.7 N.m (1.3 ~ 1.5 kgf.m, 9.4 ~ 10.8 lb-ft)
|
|
Always replace the gasket of the eyebolt use new one whenever loosening
eyebolt. |
|
Remove installation bolts in the engine compartment first and
|
|
| 5. |
Remove the bolt (3ea) after disconnecting
the solenoid valve connector (A) and the oil temperature sensor connector
(B).
Tightening torque:9.8 ~
11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
|
|
| 6. |
Remove the solenoid valve (A)
after removing the solenoid support.
|
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature
sensor connector.
3.
Measure resistance between sensor
signal terminal and sensor g ...
1.
Installation is the reverse of
removal.
•
When installing, apply
the ATF oil or white vas ...
See also:
Components(Without EPB)
1. Guide rod bolt
2. Bleed screw
3. Caliper carrier
4. Caliper body
5. Inner pad shim
6. Brake pad
7. Pad retainer
...
Components(2)
1. Rear bumper cover
2. Rear reflector
3. Rear bumper lower cover
4. Rear bumper energy absorber
5. Wiring harness
6. Rear bumper beam assembly
...
Traction Control Indicator Lights
The TCS indicator will
illuminate when the ignition key is turned to the “ON” position, but should go off
after 3 seconds. It means the TCS is in the stand-by status and at the moment of
the ...
Inspection
Installation