Kia Optima: Installation
| 1. |
Installation is the reverse of
removal. |
After replacement or reinstallation procedure of the valve body assembly,
must perform procedures below.
| • |
Continue to apply liquid
gasket at application points at the valve body cover with Ø2.5mm
(0.0984in.) thickness.
Liquid gasket Part
name :
Threebond 1281B or LOCTITE FMD-546
|
|
| • |
Adding automatic transaxle
fluid. (Refer to "Hydraulic system (Fluid)" in this group) |
|
1.
Remove the battery and the battery
tray. (Refer to "Charging system" in EE group.)
2.
Remove the under cover (A).
Tightening torque:7.8 ~
11 ...
Description
Torque converter control solenoid valve (T/CON_VFS) is attached to the valve body.
This variable force solenoid valve directly controls the hydraulic pressure inside
the torque conver ...
See also:
Lumbar support
The lumbar support can be adjusted by pressing the lumbar support switch on the
side of the drivers seat. Press the front portion of the switch to increase support,
or the rear portion of the sw ...
Power Out Side Mirror Switch. Repair procedures
Inspection
1.
Disconnect the negative (-) battery
terminal.
2.
Remove the front door trim panel.
(Refer to the BD group - "Front door")
3.
...
Sunroof
Your sunroof can be opened or closed electrically when the ignition switch is
in the “ON” position. You can slide or tilt the sunroof by depressing the corresponding
switch located on the do ...
Removal
Torque Converter Control Solenoid Valve (T/CON_VFS). Description and Operation