Kia Optima: Torque Converter Control Solenoid Valve (T/CON_VFS). Description and Operation - Automatic Transaxle Control System - Automatic Transaxle System - Kia Optima TF 2011-2024 Service ManualKia Optima: Torque Converter Control Solenoid Valve (T/CON_VFS). Description and Operation

Description

Torque converter control solenoid valve (T/CON_VFS) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the torque converter.


Installation
1. Installation is the reverse of removal. After replacement or reinstallation procedure of the valve body assembly, ...

Torque Converter Control Solenoid Valve (T/CON_VFS). Specifications
Specifications Direct control VFS[T/CON]▷ Control type : Normal low type Control Pressure kpa(kgf/cm², psi) 9.81~500.14(0.1~5.1,1.42~72.54) Curren ...

See also:

Reassembly
1. Wrap tape around the driveshaft spline(TJ) to prevent damage to the boots. 2. Apply grease to the joint boot on the side of the wheel and install the boot. ...

Supplemental Restraint System Service
Your Supplemental Restraint System is virtually maintenance-free. There are no parts which you can service. You must have the system serviced under the following circumstances: If an air bag ev ...

Removal
1. Disconnect the negative(-) battery terminal. 2. Remove the heater comtral module. (Refer to the HA group - "Controller") ...

Copyright © www.kiopman.com 2024