Kia Optima: Installation
| 1. |
Installation is the reverse of
removal. |
|
If the oil seal on the transaxle case side is damaged and fluid is leaking,
replace the oil seal with a new unit. When installing the new oil seal,
use the specialized tool (oil seal installer, 09453-3L240). |
After replacement or reinstallation procedure of the automatic transaxle
assembly, must perform procedures below.
| • |
Adding automatic transaxle
fluid. (Refer to "Hydraulic system (Fluid)" in this group) |
| • |
After servicing the automatic
transaxle or TCM, clear the diagnostic trouble codes (DTC) using
the GDS tool. Diagnostic trouble codes (DTC) cannot be cleared
by disconnecting the battery.
|
| • |
When deleting diagnostic
trouble code, use the GDS as possible. |
| • |
When replacing the automatic
transaxle, reset the automatic transaxle's values by using the GDS.
|
| • |
Perform TCM learning
after replacing the transaxle to prevent slow transaxle response,
jerky acceleration and jerky startup. (Refer to "Automatic transaxle
control system (Repair procedures)" in this group) |
|
1.
Remove the following items;
A.
Engine cover.
B.
Air cleaner assembly
and air duct (A). (Refer to "Intake and Exhaust system" in ...
See also:
Checking the washer fluid level
Check the fluid level in the washer fluid
reservoir and add fluid if necessary. Plain
water may be used if washer fluid is not
available. However, use washer solvent
with antifreeze charac ...
Battery Caution Label Description
Warning / Caution Label (Cont'd)
A.
Keep lighted cigarettes and all other flames or sparks away from the
battery.
B.
Wear eye protection when charg ...
Components and Components Location
Component Location
1. Hood switch
2. Burglar horn
3. BCM and RF antenna
4. Key warning switch
5. Front door switch
6. Front door lock actuator & switch
...
Removal
Hydraulic System