Kia Optima: Inspection
Throttle Position Sensor (TPS)
| 1. |
Connect the GDS on the Data Link Connector (DLC). |
| 2. |
Start the engine and measure the output voltage of
TPS 1 and 2 at C.T. and W.O.T.
Specification:
Refer to “Specification”
|
|
| 3. |
Turn the ignition switch OFF and disconnect the scantool
from the DLC. |
| 4. |
Disconnect the ETC module connector and measure the
resistance between the ETC module terminals 1 and 2.
Specification:
Refer to “Sensor Resistance”
|
|
ETC Motor
| 1. |
Turn the ignition switch OFF. |
| 2. |
Disconnect the ETC module connector. |
| 3. |
Measure resistance between the ETC module terminals
3 and 6. |
| 4. |
Check that the resistance is within the specification.
Specification:
Refer to “Specification”
|
|
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Remove the resonator and the air intake hose (Refer
to “Intake And Exhau ...
See also:
Inspection
[Fuel pump]
1.
Turn the ignition switch OFF, and then remove battery
(-) cable.
2.
Remove the fuel pump assembly.
3.
Check motor operatio ...
Trip Switch. Schematic Diagrams
Circuit Diagram
...
Replacement
1.
Remove the front wheel & tire.
Tightening torque:88.3
~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
Removal