Kia Optima: Removal
| 1. | Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
| 2. | Remove the resonator and the air intake hose (Refer to “Intake And Exhaust System” in EM group). |
| 3. | Disconnect the ETC module connector. |
| 4. | Disconnect the coolant hoses (B). |
| 5. |
Remove the installation bolts (A), and then remove
the ETC module from the engine.
|
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of
TPS 1 and 2 at C.T. and ...
Installation
•
Install the component with the specified
torques.
•
Note that internal d ...
See also:
Lighting control
The light switch has a Headlight and a Parking light position.
To operate the lights, turn the knob at the end of the control lever to one of
the following positions:
(1) OFF position (2) Parkin ...
Installation
OCS(Occupant Classification System) is utilizing a robust weight measuring
technology. Thus, if any of the following conditions occur ...
Engine Coolant Temperature Sensor (ECTS). Description and Operation
Description
Engine Coolant Temperature Sensor (ECTS) is located in the
engine coolant passage of the cylinder head for detecting the engine coolant
temperature. The ECTS uses a thermistor that ...
Categories
Kia Optima Manuals
- Kia Optima DL3 2019-2026 Owners Manual
- Kia Optima DL3 2019-2026 Service and Repair Manual
- Kia Optima TF 2011-{2019} Owners Manual
- Kia Optima TF 2011-2026 Service Manual
- Kia Optima MS/Magentis 2000-2005 Owners Manual
Copyright www.kiopman.com 2026