Kia Optima: Installation
| • |
Install the component with the specified
torques. |
| • |
Note that internal damage may occur when
the component is dropped. If the component has been dropped,
inspect before installing.
|
|
| 1. |
Installation is reverse of removal.
Electronic throttle body Installation bolt:9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7
lb-ft)
|
|
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Remove the resonator and the air intake hose (Refer
to “Intake And Exhau ...
Description
Manifold Absolute Pressure Sensor (MAPS) is a speed-density
type sensor and is installed on the surge tank. It senses absolute pressure
of the surge tank and transfers the analog si ...
See also:
Adjustment
1.
After loosening the trunk lid
hinge (A) mounting bolt, adjust the trunk lid by moving it up or down, or
right or left.
2.
Adjust the trunk lid height by
turnin ...
Installing a Child Restraint System in the Rear Center Seat
To install a child restraint in the rear center seat, do the following:
1. Place the child-restraint in the desired position. Route the lap/ shoulder
belt through the restraint according to the s ...
Armed stage
Park the vehicle and stop the engine. Arm the system as described below.
1. Remove the ignition key from the ignition switch and exit the vehicle.
2. Make sure that all doors (and tailgate) and engi ...
Removal
Manifold Absolute Pressure Sensor (MAPS). Description and Operation