Kia Optima: Inspection
| 1. | Check the plated parts of the disc & hub assembly (A) for color changes, peeling or other damage. If there is damage, replace the clutch set. |
| 2. | Check the pulley (B) bearing
play and drag by rotating the pulley by hand. Replace the clutch set with
a new one if it is noisy or has excessive play/drag.
|
| 3. | Check operation of the magnetic
clutch. Connect the compressor side terminals to the battery (+) terminal and the ground battery (-) terminal to the compressor body. Check the magnetic clutch operating noise to determine the condition.
|
Installation
1.
Make sure of the length of compressor
mounting bolts, and then tighten it A→B→C→D order.
Tightening torque :20.0~32.9N.m
(2.04~3.36kgf.m, 14.7~24 ...
Disassembly
1.
Disconnect the negative (-) battery
terminal.
2.
Remove the front tire (A) from
hub assembly.
Tightening torque :
10~15N.m (9~11kgf.m, 7.37~11lbf.ft ...
See also:
Inspection
Driver Door Lock Switch Inspection
1.
Disconnect the negative (-) battery
terminal.
2.
Remove the front door trim panel.
(Refer to the BD group - "Front door" ...
Seat belt warning (for front passenger’s seat)
The front passenger's seat belt warning light will activate to the following
table when the ignition switch is in "ON" position.
*1 The seat belt warning light will go off if the ...
Components and Components Location
Components Location
[Vehicle Components]
1. Automatic transaxle
2. Transaxle control module (TCM)
3. Shift lever
4. DLC
[Transaxle Components]
...
Categories
Kia Optima Manuals
- Kia Optima DL3 2019-2026 Owners Manual
- Kia Optima DL3 2019-2026 Service and Repair Manual
- Kia Optima TF 2011-{2019} Owners Manual
- Kia Optima TF 2011-2026 Service Manual
- Kia Optima MS/Magentis 2000-2005 Owners Manual
