Inspection
Lighting Switch InspectionWith the multi function switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multi-function switch.
Removal
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Disconnect the connector (A), and then remove the
sensor (B).
...
Owner maintenance schedule
When you stop for fuel:
Check the engine oil level.
Check the coolant level in coolant
reservoir.
Check the windshield washer fluid
level.
Look for low or under-inflated tires.
Whil ...
Installation
1.
Installation is the reverse of
removal.
2.
Perform the “Assembly check”
with GDS.
3.
Check that the brake operates
normally by pushing the EPB ...