Kia Optima: Auto Light Sensor. Repair procedures

Auto Light Switch. Repair procedures

Inspection Lighting Switch InspectionWith the multi function switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the ...

Inspection

In the state of IGN1 ON, when multi function switch module detects auto light switch on, tail lamp relay output and head lamp low relay output are controlled according to auto light sensor's i ...

See also:

Schedule 1 - Severe Maintenance
I: Inspect and, if necessary, adjust, correct, clean or replace. R: Replace or change. ...

Inspection
1. Measure terminal-to-terminal resistance of the blower resistor. 2. measured resistance is not within specification, the blower resistor must be replaced. (After re ...

Repair procedures
General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and i ...