1. | Disconnect the negative(-) battery terminal. |
2. | Remove the glove box. (Refer to the BD group - "Crash pad") |
3. | Disconnect the fob holder connector
(A).
|
4. | Remove the fob holder (A) after
removing the screws.
|
Hazard Warning Flasher
The hazard warning flasher causes the rear tail lights and front turn signal
lights to flash on and off, which serves as a warning to other drivers to exercise
caution when approaching or passin ...
Components and Components Location
Components Location
1. Receiver
2. TPMS sensor (FL)
3. TPMS sensor (RL)
4. TPMS sensor (RR)
5. TPMS sensor (FR)
...
ECM Problem Inspection Procedure
1.
TEST ECM GROUND CIRCUIT: Measure resistance between
ECM and chassis ground using the backside of ECM harness connector as
ECM side check point. If the problem is found, repa ...