The mode selection button controls the direction of the air flow through the ventilation system.
The air flow outlet port is same as manual climate control system.
Face position
Air flow is directed
toward the upper body and face. Additionally, each outlet can be controlled to direct
the air discharged from the outlet. (outlet port: , )
Face - floor position
Air flow is directed
towards the face and the floor. The air to the floor is warmer than the air to the
face (except when the temperature control is set to the extreme cold position).
Floor position
Most of the air flow
is directed to the floor, with a small amount of the air being directed to the windshield
and side window defroster.
Floor - defrost position
Most of the air flow
is directed to the floor and the windshield with a small amount directed to the
side window defrosters.
In automatic operation, the air conditioning system will automatically cycle on and the outside (fresh) air position will be selected. To cancel, press the outside (fresh) air button on the instrument panel once.
To fasten the front lap/shoulder belt
1. Grasp the buckle and tongue plate.
2. Slowly pull the lap/shoulder belt out from the retractor.
3. Insert the tongue plate into the open end of the buckle until an audible “click”
is heard, ...
Start/Stop Button Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the crash pad side cover (A).
3.
After loosening the mounting screws, then remove the cra ...
Rear Lower Arm Repair procedures
Replacement
1.
Remove the rear wheel & tire.
Tightening torque:
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
Be careful not to damage the hub bolts wh ...