Kia Optima: Repair procedures - Multifunction switch - Body Electrical System - Kia Optima TF 2011-2018 Service ManualKia Optima: Repair procedures

Components and Components Location
Component(1) Component(2) <Installation order : A→B→C→D→E> 1. Steering column shaft 2. Lighting switch 3. Wiper and washer switch 4. ...

Inspection
Lighting Switch InspectionWith the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multi-functio ...

See also:

Removal and Installation
1. Disconnect the battery negative terminal first, then the positive terminal. Tightening torque :(+) terminal : 7.8 ~ 9.8N.m (0.8 ~ 1.0kgf.m, 5.8 ~ 7.2l ...

Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. Condition ...

Escort welcome (if equipped)
When the headlight(light switch in the headlight or AUTO position) is on and all doors (and trunk) are locked and closed, the position light and headlight will come on for 15 seconds if any of the ...

Copyright © www.kiopman.com 2018