Kia Optima: Installation - Repair procedures - Multifunction switch - Body Electrical System - Kia Optima TF 2011-2020 Service ManualKia Optima: Installation

1. Install the multifunction switch.
2. Install the clock spring.
3. Install the steering column upper and lower shrouds.
4. Install the steering wheel.
Make sure the multifunction switch connectors are plugged in properly.

Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the steering wheel. (Refer to the ST group - "Steering column & shaft") 3. ...

Horn
...

See also:

Oil Pump. Description and Operation
Description The oil pump is built-in as a single unit with the 26 brake chamber. Rotation of the pump builds the hydraulic pressure needed for the lubrication of the various parts of the transaxl ...

Inspection
Radiator Cap Testing 1. Remove the radiator cap, wet its seal with engine coolant, and then install it on a pressure tester. 2. Apply a pressure of 93.16 ~ 122.58k ...

Replacement (Without EPB)
Rear brake pads 1. Loosen the guide rod bolt (B) and pivot the caliper (A) up out of the way. Tightening torque:21.6 ~ 31.4 N.m (2.2 ~ 3.2 kgf.m, 15.9 ~ 23.1 lb-ft) ...

Copyright © www.kiopman.com 2020