Kia Optima: Inspection - Auto Head Lamp Leveling Unit. Repair procedures - Auto Head Lamp Leveling Device - Body Electrical System - Kia Optima TF 2011-2019 Service ManualKia Optima: Inspection

1. Ignition "ON".
2. Turn on the head lamp switch.
3. Check for operation. If the aim of the head lamps changes smoothly when the head lamp leveling switch is turned.
4. If the operation does not work well, inspect the connector and terminals to be sure they are all making good contact.

If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.

If the terminals look OK, go to step 5.
5. Substitute with a known-good head lamp assembly and check for proper operation.

Auto Head Lamp Leveling Unit. Repair procedures
...

Removal
1. Remove the head lamp leveling unit connector (A). 2. Loosen the mounting bolts (3EA) of automatic head lamp leveling unit assembly. Tighting torq ...

See also:

Inspection
With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat switch. A : Power seat control s ...

Installation
Installation is the reverse of removal. Canister installation bolt:3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft) ...

Driving in flooded areas
Avoid driving through flooded areas unless you are sure the water is no higher than the bottom of the wheel hub. Drive through any water slowly. Allow adequate stopping distance because brake perf ...

Copyright © www.kiopman.com 2019