1. | Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. | Disconnect the ventilation hose (A) from the fuel tank air filter. |
3. |
Disconnect the vapor tube quick-connector (B) and
the quick-connector (C).
|
4. |
Remove the rear muffler assembly.
(Refer to "Intake and Exhaust System") |
5. | Remove the protector cover (A) in the direction of arrow. |
6. |
Remove installation bolts and then remove the canister
assembly (B).
|
7. |
Remove the bracket (A) from the canister after removing
a bolts (B).
|
Components and Components Location
Component Location
[Vehicle Installation component]
1. Automatic transaxle2. Transaxle control module (TCM)3. Shift lever4. Data Link Connector (DLC)
[Transaxle Installation component]
1. ...
Interior Trim Repair procedures
Replacement
Door Scuff Trim Replacement
•
Put on gloves to protect your hands.
•
Use a plastic panel removal tool to remove interior trim pieces t ...
Limp home (override) procedure
When you turn the ignition switch to the ON position, if the immobilizer indicator
() goes off after blinking 5 times, your
transponder equipped in the ignition key is out of order. You cannot sta ...