Kia Optima: Removal - Rear Upper Arm. Repair procedures - Rear Suspension System - Suspension System - Kia Optima TF 2011-2019 Service ManualKia Optima: Removal

1. Remove the rear wheel & tire.

Tightening torque:

88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)


Be careful not to damage the hub bolts when removing the rear wheel & tire.
2. Loosen the bolt & nut and then remove the rear upper arm (A) with the rear axle.

Tightening torque:

137.3~156.9N.m(14.0~16.0Kgf.m, 101.3~115.7lb-ft)


3. Set up the transmission jack (A) under the lower arm (B).

4. Loosen the bolt & nut and then remove the rear upper arm (A) with the rear axle.

Tightening torque:

137.3~156.9N.m(14.0~16.0Kgf.m, 101.3~115.7lb-ft)


Х When removing the bolt, remove the upper arm in no-load condition by using the transmission jack.

5. Loosen the bolt & nut and then remove the rear upper arm (A) with the sub frame.

Tightening torque:

156.9~176.5N.m(16.0~18.0Kgf.m, 115.7~130.2lb-ft)


Х When removing the bolt, remove the upper arm in no-load condition by using the transmission jack.


Rear Upper Arm. Repair procedures
...

Installation
1. Installation is the reverse of removal. Х If you don't ...

See also:

Mode Control Actuator. Description and Operation
Description The mode control actuator is located at the heater unit.It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select s ...

Inspection
1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim.(Refer to the BD group - "Roof trim") 3. Disconnect the panoram ...

Opening the Hood
1. Pull the release lever on the lower left side of the instrument panel to unlatch the hood. 2. Go to the front of the vehicle, slightly raise the hood, pull up on the secondary latch and li ...

Copyright © www.kiopman.com 2019