Kia Optima: Mode Control Actuator. Description and Operation - Temperature Control Actuator - Heating,Ventilation, Air Conditioning - Kia Optima TF 2011-2021 Service ManualKia Optima: Mode Control Actuator. Description and Operation

Description

The mode control actuator is located at the heater unit.

It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select switch makes the mode control actuator shift in order of vent→ B/L → floor → mix.


Mode Control Actuator. Components and Components Location
Component Location ...

Mode Control Actuator. Repair procedures
...

See also:

Balance Shaft & Oil Pump Repair procedures
Removal Balance Shaft Module (BSM) Chain System 1. Remove the timing chain. (Refer to Timing system in this group) 2. Install a stopper pin (A) after compressing the balance shaft chain tensi ...

Removal
1. Disconnect the negative(-) battery terminal. 2. Remove the lens trunk trim. (Refer to the BD group - "Trunk") 3. Replace the bulb (A) ...

Panoramaroof Motor Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim. (Refer to the BD group - "Roof trim") 3. Disconnect the panoramaroof motor (A) connector. 4. Grou ...

Copyright © www.kiopman.com 2021