Kia Optima: Removal - Manifold Absolute Pressure Sensor (MAPS). Repair procedures - Engine Control System - Engine Control/Fuel System - Kia Optima TF 2011-2026 Service ManualKia Optima: Removal

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2. Disconnect the manifold absolute pressure sensor connector (A).
3. Remove the installation bolts (B), and then remove the sensor from the surge tank.

[MAPS #1]

[MAPS #2]

[MAPS #2]


Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the MAPS at idle and IG ON. Specification: Refer to " ...

Installation
• Install the component with the specified torques. • Note that internal d ...

See also:

Carry emergency equipment
Depending on the severity of the weather you should carry appropriate emergency equipment. Some of the items you may want to carry include tow straps or chains, flashlight, emergency flares, ...

Lumbar Support (Driver’s Seat Only)
You can adjust the lumbar support by moving the lever on the right side of the driver’s seatback. Pivoting the lever toward the front of the vehicle increases the lumbar support. Pivoting the ...

Precautions
✽ NOTICE The transmitter (or smart key) will not work if any of following occurs: The ignition key is in the ignition switch. You exceed the operating distance limit (about 30 m [90 feet ...

Copyright www.kiopman.com 2026