Inspection
1. | Remove the cowl top cover. (Refer to the wiper) |
2. | Disconnect the windshield deicer
connector (A) from the wiper motor linkage.
|
3. | Check for continuity between
the terminals of deicer lines.
|
4. | Turn the ignition switch ON and
the windshield deicer switch ON, then measure the voltage between the terminals
of harness side deicer connector.
|
Additional Programming for Rolling Code Devices
For any rolling-code-equipped device; follow the steps below after completing
the "Programming" section. A second person may make the following steps easier.
1. Locate the "learn&quo ...
Air intake control
The air intake control is used to select outside (fresh) air position or recirculated
air position.
To change the air intake control position, push the control button.
Recirculated air position
...
How to use this manual
We want to help you get the greatest possible driving pleasure from your vehicle.
Your Owner’s Manual can assist you in many ways. We strongly recommend that you
read the entire manual. In order t ...