Kia Optima: TPMS Sensor. Description and Operation - Tire Pressure Monitoring System - Suspension System - Kia Optima TF 2011-2026 Service ManualKia Optima: TPMS Sensor. Description and Operation

Description

1. Mode
(1) Configuration State
A. All sensors should be in the Low Line state.
B. In Low Line configuration, sensor transmissions occur every 1 minute (nominal) and pressure is measured every 4 seconds.
(2) Normal Delayed Auto State
A. This is Low Line specific and is used for all High Line applications.
B. In this state, the sensor will transmit for approx. 12 minutes before automatically entering storage state.
(3) Storage Auto State
A. This state is a Low quiescent current state.
B. In this state;
1) Ignition off.
2) The sensor does not measure pressure / temperature / battery level.
3) The sensor will not transmit, unless requested to do so by the initiate command.
(4) Alert State
A. The sensor automatically enters this state if the measured temperature exceeds 110°C and over temperature shutdown is likely.
B. In this state, pressure is measured every 4 seconds and RF data transmitted every 4 seconds.
C. The state lasts for 1 minute if it is pressure triggered.

Description and Operation
Description Tread Lamp - Tire Under Inflation / Leak Warning. 1. Turn on condition A. When tire pressure is below allowed threshold ...

TPMS Sensor. Repair procedures
...

See also:

Child seat anchorage position
For small children and babies, the use of a child seat or infant seat is strongly recommended. This child seat or infant seat should be of appropriate size for the child and should be installed in ...

Removal
1. Remove the rear wheel & tire. Tightening torque:88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes. 3. Tighten the curtain airb ...

Copyright www.kiopman.com 2026