Storing driver’s seat positions
1. Shift the shift lever into P while the ignition switch is ON.
2. Adjust
the driver seat to position comfortable for the driver.
3. Press SET button on
the control panel. The system will beep once.
4. Press one of the memory buttons
(1 or 2) within 5 seconds after pressing the SET button. The system will beep twice
when memory has been successfully stored.
Recalling positions from memory
1. Shift the shift lever into P while the ignition switch is ON.
2. To recall
the position in memory, press the desired memory button (1 or 2). The system will
beep once, then the driver seat will automatically adjust to the stored positions.
Adjusting the control switch for the driver seat while the system is recalling the stored position will cause the movement to stop and move in the direction that the control switch is moved.
WARNING
Use caution when recalling adjustment memory while sitting in the vehicle. Push the seat position control knob to the desired position immediately if the seat moves too far in any direction.
Removal
1.
Loosen the drain plug, and drain
the coolant. Remove the radiator cap to speed draining.
2.
Disconnect the oil cooler coolant
hoses (A).
3.
...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the HO2S connector.
3.
Measure resistance between the HO2S terminals 4 and
5 [B1/S1].
...
Hazard warning flasher
Type A
Type B
The hazard warning flasher should be used whenever you find it necessary to stop
the car in a hazardous location. When you must make such an emergency stop, always
pull off the ...