Kia Optima: Resetting The Panoramaroof
Whenever the vehicle battery is disconnected or discharged, or you use the emergency
handle to operate the panoramaroof, you have to reset your panoramaroof system as
follows :
| 1. |
Turn the ignition key to the
ON position and then close the panoramaroof completely. |
| 2. |
Release the panoramaroof control
lever. |
| 3. |
Press and hold the CLOSE button
for more than 10 seconds until the panoramaroof has moved slightly. |
| 4. |
Release the panoramaroof control
lever. |
| 5. |
Press and hold the CLOSE button
once again within 3 seconds until the panoramaroof do as follows;
| A. |
Tilt → Slide Open → Slide
Close Then release the lever.
|
|
| 6. |
Reset procedure of panorama system
is finished. |
Protecting Motor From Overheating
In order to protect the panoramaroof motor from
overheating from continuous motor operation, the panoramaroof ECU controls the Run-time
and Cool-time of the motor as follows:
| 1. |
The panoramaroof ECU detects
the Run- time of motor |
| 2. |
Motor can be operated continuously
for the 1st run-time(120 ± 10sec.). |
| 3. |
The continuous operation of motor
stops after the 1st Run-time(120 ± 10sec.). |
| 4. |
Then Motor is not operated for
the 1st Cool-time(18 ± 2sec.). |
| 5. |
Motor is operated for the 2nd
Run-time(10 ± 2sec.) at the continued motor operation after 1st Cool-time(18
± 2sec.) |
| 6. |
The continuous operation of motor
stops operating after the 2nd Run-time(10 ± 2sec.) |
| 7. |
Motor is not operated for the
2nd Cool-time(18 ± 2sec.). |
| 8. |
Motor repeats the 2nd run-time
and 2nd cool-time at the continued motor operation.
| A. |
In case that motor is
not operated continuously, the run-time is increased. |
| B. |
The Run-Time of motor
is initialized to "0" if the battery or fuse is reconnected after
being disconnected, discharged or blown. |
T1 : 120 ± 10 sec., T2 : 18 ± 2 sec.,T3 : 10 ± 2 sec., T4 : 18 ± 2 sec.
|
1.
Disconnect the negative (-) battery
terminal.
2.
Remove the roof trim.(Refer
to the BD group - "Roof trim")
3.
Disconnect the panoram ...
See also:
Driving in flooded areas
Avoid driving through flooded areas unless you are sure the water is no higher
than the bottom of the wheel hub. Drive through any water slowly. Allow adequate
stopping distance because brake perf ...
Head Lamp Aiming Instructions
<Mechanical aiming>
The head lamps should be aimed with the proper beam-setting equipment, and in accordance
with the equipment manufacturer's instructions.
...
Disassembly
1.
Remove the snap ring (A).
2.
Remove the hub assembly from
the knuckle assembly.
(1)
Install the front knuckle
assembly (A) on press.
...
Inspection
Lighting System