1. | Disconnect the negative (-) battery terminal. |
2. | Remove the main crash pad lower
cover (A).
|
3. | Disconnect the connector (A) of the blower motor. |
4. | Remove the blower motor (B) after
loosening the mounting screws.
|
5. | Installation is the reverse order of removal. |
Oil Pressure Switch. Repair procedures
Inspection
1.
Check the continuity between
the terminal and the body with an ohmmeter.If there is no continuity,
replace the oil pressure switch.
2.
Ch ...
Air cleaner
Filter replacement
It must be replaced when necessary, and
should not be washed.
You can clean the filter when inspecting
the air cleaner element.
Clean the filter by using compressed air. ...
Rail Pressure Sensor (RPS). Troubleshooting
Signal Waveform
...