Kia Optima: Replacement
| 1. | Disconnect the negative (-) battery terminal. |
| 2. | With the (-) driver, remove the
photo sensor (A) from the center of defrost nozzle.
|
| 3. | Install in the reverse order of removal. |
Inspection
1.
Ignition "ON"
2.
Using the scan tool.
3.
Emit intensive light toward photo
sensor using a lamp, and check the output voltage change.
...
Ambient Sensor. Description and Operation
Description
1.
The ambient temperature sensor
is located at the front of the condenser and detects ambient air temperature.
It is a negative type thermistor; resistance will increas ...
See also:
Cowl Top Cover. Repair procedures
Replacement
1.
Remove the cap (B) and remove
the nuts, then remove the wiper arm (A).
Tightening torque :22.6~26.5
N.m(2.3~2.7 kgf.m, 16.6~19.5 lb-ft)
...
Inspection
1.
Measure the pressure of high
pressure line by measuring voltage output between NO.1 and NO.2 terminals.
2.
Inspect the voltage value whether
it is sufficie ...
Using USB device
CAUTION IN USING USB DEVICE
To use an external USB device, make sure the device is not connected when
starting up the vehicle. Connect the device after starting up.
If you start the engine w ...
Copyright © www.kiopman.com 2024