Kia Optima: Removal
| 1. | Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
| 2. |
Disconnect the connector (A), and then remove the
sensor (B).
|
![[Bank 1 / Sensor 1]](images/books/928/syffl0308n.gif)
![[Bank 1 / Sensor 2]](images/books/928/stffl2051n.gif)
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the HO2S connector.
3.
Measure resistance between the HO2S terminals 4 and
5 [B1/S1].
...
Installation
•
Install the component with the specified
torques.
•
Note that internal damag ...
See also:
Inspection
1.
Check the bushing for wear and
deterioration.
2.
Check the rear lower arm for
deformation.
3.
Check the coil spring and spring
pad for deterior ...
Line Pressure Control Solenoid Vale. Specifications
Specifications
Direct control VFS[LINE Pressure]▷ Control type : Normal low type
Control Pressure kpa(kgf/cm², psi)
500.14~9.81(5.1~0.1,72.54~1.42)
...
Tires and wheels
CAUTION
When replacing tires, use the same
size originally supplied with the
vehicle.
Using tires of a different size can
damage the related parts or make it
work irregularly. ...
Copyright © www.kiopman.com 2025