Kia Optima: Installation
| • |
Install the component with the specified
torques. |
| • |
Note that internal damage may occur when
the component is dropped. If the component has been dropped,
inspect before installing. |
|
| • |
DON’T use a cleaner, spray, or grease to
sensing element and connector of the sensor because oil component
in them may malfunction the sensor performance. |
| • |
Sensor and its wiring may be damaged in case
of contacting with the exhaust system (Exhaust Manifold, Catalytic
Converter, and so on).
|
|
| 1. |
Installation is reverse of removal.
Heated oxygen sensor installation (Bank 1/
Sensor 1):
39.2 ~ 49.1 N.m (4.0 ~ 5.0 kgf.m, 28.9 ~
36.2 lb-ft)
Heated oxygen sensor installation (Bank 1/
Sensor 2):
35 ~ 45 N.m (3.6 ~ 4.6 kgf.m, 25.8 ~ 33.2
lb-ft)
|
|
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Disconnect the connector (A), and then remove the
sensor (B).
...
Description
Rail Pressure Sensor (RPS) is installed on the delivery pipe
and measures the instantaneous fuel pressure in the delivery pipe. The sensing
element (Semiconductor element) built in ...
Removal
Rail Pressure Sensor (RPS). Description and Operation