Kia Optima: Removal
| 1. |
Remove the timing chain. (Refer
to Timing system in this group) |
| 2. |
Install a stopper pin (A) after
compressing the balance shaft chain tensioner. |
| 3. |
Remove the balance shaft chain
hydraulic tensioner (B). |
| 4. |
Remove the balance shaft chain
tensioner arm (C). |
| 5. |
Remove the balance shaft chain
guide (D).
|
| 6. |
Remove the balance shaft & oil
pump module (A) and balance shaft chain (B) and the sprocket (C).
|
Do not disassemble the balance shaft & oil pump module. |
|
1.
The key of crankshaft should
be aligned with the mating face of main bearing cap. As a result of this,
the piston of No.1 cylinder is placed at the top dead center on compression ...
See also:
Blower Unit. Repair procedures
Replacement
1.
Disconnect the negative (-) battery
terminal.
2.
Remove the crash pad and heater
blower unit.(Refer to HA group-heater unit)
3.
Re ...
Replacement (With EPB)
Rear brake pads
1.
Remove the rear wheel & tire.
2.
Connect the GDS to the data link
connector located underneath the dash panel.
3.
Ignition "ON& ...
Checking the coolant level
WARNING
Removing radiator
cap
Never attempt to remove the radiator
cap while the engine is operating
or hot. Doing so might lead
to cooling system and engine
damage. Also, hot ...
Installation