Kia Optima: Removal
| 1. |
Remove the front wheel and tire.
Tightening torque:88.3
~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
|
|
| 2. |
Remove the front wheel speed
sensor mounting bolt (A).
Tightening torque:7.8 ~
9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)
|
|
| 3. |
Remove the front wheel guard
. |
| 4. |
Remove the front wheel speed
sensor cable mounting bolt. |
| 5. |
Disconnect the front wheel speed
sensor connector, then remove the front wheel speed sensor. |
| 6. |
Installation is the reverse of
removal. |
1.
Measure the output voltage between
the terminal of the wheel speed sensor and the body ground.
...
See also:
Inspection
TCM Problem Inspection Procedure
1.
TEST TCM GROUND CIRCUIT: Measure
resistance between TCM and chassis ground using the backside of TCM harness
connector as TCM side check point. If ...
Inspection
With the power seat switch in each position, make sure that continuity exists between
the terminals below. If continuity is not as specified, replace the power seat switch.
A : Power seat control s ...
Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional
hydraulic pressure adjustment; however, the hydraulic pre ...
Inspection