Kia Optima: Removal - Seat Belt Pretensioner (BPT). Repair procedures - Seat Belt Pretensioner - Restraint - Kia Optima TF 2011-2023 Service ManualKia Optima: Removal

1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2. To remove the seat belt anchor pretensioner (C), keep on pushing the lock pin (A) as arrow direction. And then remove the seat belt after pushing the lock pin (B).

3. Remove the door scuff trim. (Refer to the Body group- Interior trim)
4. Remove the center pillar trim. (Refer to the Body group- Interior trim)
5. Remove the upper anchor bolt.
6. Disconnect the seat belt pretensioner connector (A).

7. Loosen the seat belt pretensioner mounting bolts (B, C) and remove the seat belt pretensioner.

Seat Belt Pretensioner (BPT). Repair procedures
...

Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes. 3. Install the seat belt ...

See also:

Safety Belt Warning
As a reminder to the driver and passenger, safety belt warning light will blink for approximately 6 seconds each time you turn the ignition switch ON. If the driver's lap/shoulder belt is not ...

Changing the Manual Transaxle Oil
1. Raise and suitably support the vehicle. 2. Remove the drain plug on the bottom of the transaxle. 3. After the oil has drained completely, install a new washer on the plug, reinstall the drain p ...

Tachometer
Type A Type B The tachometer indicates the approximate number of engine revolutions per minute (rpm). Use the tachometer to select the correct shift points and to prevent lugging and/or ove ...

Copyright © www.kiopman.com 2023