Kia Optima: 26 Brake Control Solenoid Valve(26/B_VFS). Description and Operation

Removal

Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the hydraulic pre ...

26 Brake Control Solenoid Valve(26/B_VFS). Specifications

Specifications Direct control VFS[26/B]▷ Control type : Normal low type Control Pressure kpa(kgf/cm², psi) 9.81~500.14(0.1~5.1, 1.42~72.54) Curren ...

See also:

Receiver-Drier. Repair procedures
Replacement 1. Remove the condenser, and then remove the bottom cap (B) with L wrench (A) from the condenser. Tightening torque :20~25N.m (2.0~2.5kgf.m, 14.5~18.2lb-ft) ...

Diagnosis procedure by using diagnostic device
As manual for diagnosis methods by using diagnosis device, the main contents are as follows: 1. Connect self-diagnosis connector(16pins) located in the lower of driver side crash pad to ...

Compass Mirror. Repair procedures
Calibration Procedure If the compass has been calibrated or set to variance zone number incorrectly, or you are driving in specific places (tunnel, parking lot in building, underground parking lo ...