Kia Optima: Reassembly - Camshaft. Repair procedures - Cylinder Head Assembly - Engine Mechanical System - Kia Optima TF 2011-2022 Service ManualKia Optima: Reassembly

1. Reassemble the CVVT assembly (A) and camshaft (B).

Tightening torque :

53.9 ~ 63.7N.m (5.5 ~ 6.5kgf.m, 39.7 ~ 47.0lb-ft)


When installing the CVVT assembly bolt, prevent the camshaft from rotating by using a wrench.

Disassembly
1. Disassemble the CVVT assembly (A) and camshaft (B). When removing the CVVT assembly bol ...

Cylinder Head. Components and Components Location
  1. Camshaft bearing cap 2. Camshaft front bearing cap 3. Exhaust camshaft 4. Intake camshaft 5. Exhaust CVVT assembly 6. Intake CVVT assembly 7. Exhaus ...

See also:

Inspection
1. Turn ignition switch OFF. 2. Disconnect the oil temperature sensor connector. 3. Measure resistance between sensor signal terminal and sensor g ...

Audio Unit Components and Components Location
Components Connector Pin Information Pin No.Connector A (18pin)Connector B (24pin)1Rear left speaker (+)-2Front left speaker (+)-3Front right speaker (+)-4Rear right speaker (+)Steering remocon5 ...

Panoramaroof Switch Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the overhead console lamp assembly. (Refer to the BD group - "Roof trim") 3. Check for continuity between the termina ...

Copyright © www.kiopman.com 2022