Kia Optima: Measuring Actual Dimensions
| 1. | These dimensions indicate the actual linear distance between measurement points, and are used as the reference dimensions when a tracking gauge is used for measurement. |
| 2. | First adjust both probes
to the same length (A=A') before measurement.
|
Dimensions Projected
1.
These are the dimensions
measured when the measurement points are projected from the vehicle's surface,
and are the reference dimensions used for used for body alterations ...
Measurement Point
Measurements should be taken at the center of the hole.
...
See also:
Rear Cross Member. Repair procedures
Replacement
1.
Remove the rear wheel & tire.
Tightening torque:88.3
~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
Component Location (2)
1. FOB holder
2. Door outside handle
3. Trunk lid open switch
4. FOB key
...
Inspection
Check it by the procedure below to see if the function of the ECM is normal.
1.
Turn the ignition key to the
"ON" position.
2.
Cover the front sensor to stop
...
Categories
Kia Optima Manuals
- Kia Optima DL3 2019-2026 Owners Manual
- Kia Optima DL3 2019-2026 Service and Repair Manual
- Kia Optima TF 2011-{2019} Owners Manual
- Kia Optima TF 2011-2026 Service Manual
- Kia Optima MS/Magentis 2000-2005 Owners Manual
Copyright www.kiopman.com 2026