Kia Optima: Dimensions Projected
| 1. | These are the dimensions measured when the measurement points are projected from the vehicle's surface, and are the reference dimensions used for used for body alterations. |
| 2. | If the length of the tracking
gauge probes is adjustable, measure it by lengthening one of two probes
as long as the different value in height of the two surface.
|
Measuring Body Dimensions
1.
Basically, all measurements
in this manual are taken with a tracking gauge.
2.
When a measuring tape is
used, check to be sure there is no elongation, twis ...
Measuring Actual Dimensions
1.
These dimensions indicate
the actual linear distance between measurement points, and are used as the
reference dimensions when a tracking gauge is used for measurement.
...
See also:
Proper Use and Care of the Safety Belt System
To ensure that the safety belts provide the maximum protection, please follow
these instructions:
Use the belts at all times - even on short trips.
If the safety belt is twisted, straighten it ...
Camshaft Position Sensor (CMPS). Schematic Diagrams
Circuit Diagram
...
Rheostat. Repair procedures
Inspection
1.
Disconnect the negative (-) battery
terminal.
2.
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad")
3.
...
Categories
Kia Optima Manuals
- Kia Optima DL3 2019-2026 Owners Manual
- Kia Optima DL3 2019-2026 Service and Repair Manual
- Kia Optima TF 2011-{2019} Owners Manual
- Kia Optima TF 2011-2026 Service Manual
- Kia Optima MS/Magentis 2000-2005 Owners Manual
Copyright www.kiopman.com 2026