Installation
1.
The key of crankshaft should
be aligned with the mating face of main bearing cap. As a result of this,
the piston of No.1 cylinder is placed at the top dead center on compression ...
Oil Pump. Components and Components Location
Components
1. Reaction shaft support assembly
2. Oil pump housing
3. Driven gear
4. Drive gear
5. Oil seal
6. Bushing-Housing
7. Reaction shaft
8. Bushin ...
Removal
[Bank 1 / Intake]
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Remove the OTS (A).
3.
Disco ...