Kia Optima: Installation
| • |
Install the component with the specified
torques. |
| • |
Note that internal damage may occur when
the component is dropped. If the component has been dropped,
inspect before installing. |
|
| • |
Apply the engine oil to the O-ring. |
|
| • |
Insert the sensor in the installation hole
and be careful not to damage.
|
|
| 1. |
Installation is reverse of removal.
Crankshaft position sensor installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)Crankshaft position sensor protector installation
bolt (M6): 9.8 ~ 11.8 N.m (1.0 ~ 1.2
kgf.m, 7.2 ~ 8.7 lb-ft)
Crankshaft position sensor protector installation
bolt (M8): 18.6 ~ 23.5 N.m (1.9 ~
2.4 kgf.m, 13.7 ~ 17.4 lb-ft)
|
|
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Disconnect the crankshaft position sensor connector
(A).
...
Description
Camshaft Position Sensor (CMPS) is a hall sensor and detects
the camshaft position by using a hall element.It is related with Crankshaft Position Sensor (CKPS) and
detects the pisto ...
See also:
Troubleshooting
Trouble Shooting
Ignition System
Symptom
Suspect area
Remedy
Engine will not start or is hard to start (Cranks OK)
Ignition lock switch
...
Disassembly
-
Do not work in a dusty
or dirty place.
-
Do not touch the circuit
board with ...
Non-operational conditions of rear parking assist system
The rear parking assist system may not operate properly when:
1. Moisture is frozen to the sensor. (It will operate normally when the moisture
has been cleared.) 2. The sensor is covered with forei ...
Removal
Camshaft Position Sensor (CMPS). Description and Operation