Kia Optima: Removal - Crankshaft Position Sensor (CKPS). Repair procedures - Engine Control System - Engine Control/Fuel System - Kia Optima TF 2011-2026 Service ManualKia Optima: Removal

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2. Disconnect the crankshaft position sensor connector (A).

3. Remove the protector (A).

4. Remove the installation bolt (A), and then remove the crankshaft position sensor.


Inspection
1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” ...

Installation
• Install the component with the specified torques. • Note that internal d ...

See also:

Remote keyless entry system operations
Type A Type B Lock (1) All doors are locked if the lock button is pressed. If all doors (and trunk) are closed, the hazard warning lights will blink once to indicate that all doors (and tru ...

Changing Coolant
Change coolant according to the Scheduled Maintenance. Use only soft (de-mineralized) water in the coolant mixture. The engine in your vehicle has aluminum engine parts and must be protected ...

Windshield washers
In the OFF position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles. Use this function when the windshield is dirty. The spray and wipe ...

Copyright � www.kiopman.com 2026